Access Control Kit 7 is a keypad access control system with fail secure lock release, exit button, power supply and dual PIN and/or key fob door reader for standard PIN/fob access control requirements
Access control for home, access control for office or any other access control solution required
** The fail secure lock release requires power to unlock, therefore it is not recommended for connection to a fire alarm as continued power to the lock release will cause irreparable damage to the lock release coil. Connection to a fire alarm would require a fail open lock release accompanied with a green emergency break switch which are an optional choice available when ordering this access control system
Both fail secure & fail safe lock releases are compatible with a typical Yale or similar rim or mortice latch which you will require. They are not compatible with a deadlock locking device
Connection drawings 
Quick programming guide Keypad manual Lock ReleaseLock style: Fail locked (Power required to un-lock)
12v ac/dc Coil impedance: 30 ohms
Current consumption: 760ma - 900ma
Holding force: 300kg
Supplied with: Both mortice and surface mounted face plates
Size: 160h x 25w x 31d mm
Exit buttonSurface mounted plastic exit button
Single gang surface mount
Changeover contacts (C/NO/NC)
Size: 85w x 85w mm
Digital keypad K401-IE12v-24v DC fully featured self-contained high security digital keypad, proximity card and key fob reader manufactured from vandal resistant electroplated Zinc Alloy - ideal for internal or external use
A cost effective '3 in 1' keypad with a huge specification providing PIN, key fob or PIN & key fob access
4 - 6 PIN with #Main featuresRain hood: No, not required
Input: 12v-24v DC input
Current rating: 50ma
IP rating: IP66, weather resistant and vandal resistant
Keypad: Back - lit blue illuminated button keypad
Back box: Vandal resistant electroplated Zinc Alloy with 750 mm cable tail
User codes: 1000 User codes and/or key fobs or cards for relay 1
Card or key fob: The keypad uses standard EM-RFID proximity cards or key fobs
Relay outputs: One, maximum relay output @ 3amp with N.C. & N.O. contacts
Relay output timers: One from 1 second to 99 seconds
Exit button input: Yes
Fitting: Surface mount
Size: 120h x 76w x 25d mm
Cable tail size: 900 mm
A) All features are keyboard programmable
B) Non-volatile memory in the event of a power failure
C) 3 LED display indication status
Power supplyIvory white cabinet (Small)
Switch mode 13.8 volt dc regulated output 1amp power supply
Additional battery charging output
Battery deep discharge protection (Electronic)
LED Indication for mains input, DC output & battery charge/low charge
Multiple cable entry point
Size of power supply: 225h x 195w x 75d mm
Can the keypad be installed outside?Yes, the keypad is IP66 rated for internal or external use
Is the lock release for external use?If in direct line of rain then no, the lock connections must be concealed to avoid weather damage
Is this system easy to install?This will depend upon your experience, however, it is not too difficult, neither is it difficult to program the keypad. There are drawings for this in the "Specification & Manual" tab
Can I have two keypads, one for entering and one for exiting?Yes if you wish, just order an addtional keypad
HereWhat cable do I need? You can use any cable you like for this, we suggest using 3 paired or 4 paired standard alarm cable that you can purchase from any local electrical or DIY store
Tech TipsIt is advisable to periodically clean the keypad facia to prevent ingress of dirt or general grime which will accumulate between the buttons and could cause the keypad buttons to become "Sticky". This is common with all mechanical moving parts and more so dependent upon the installation area and general usage, however, regular preventive maintenance will ensure long lasting operation of the item
